Typical characteristics of Intelligent manual spraying painting machine

1. ^{Quick and simple color change}

2. ^{Enhanced coating quality of flat and complex parts
   • Reduced operator fatigue
   • Effective coating in corners and recesses
   • Improved recoating ability}

Technical Data

^{Electrical data}

1. ^{Power range                                  220V/110V}
2. ^{Frequency                                     50HZ /60HZ}
3. ^{Temperature range in use                      -10 ℃+50 ℃}

^{Powder Gun}

1. ^{Gun weight:    ………………                    500G}
2. ^{Rated output voltage ………                      24VDC}
3. ^{Input voltage     ……………                       - 200kv}
4. ^{Maximum output current  ………                   180Ua(max)}
5. ^{Maximum output voltage…………                   0-100KV (  adjustable)}   
6. ^{Maximum powder injection :………                    600g/min}
7. ^{Polarity ………………                                negative (-)}  

^{Pneumatic data}

1. ^{Maximum input-air pressure …………..                 10kg/cm}
2. ^{Optimum input-air pressure……..                        6kg/cm}
3. ^{Minimum input-air pressure   ……                      4kg/cm}
4. ^{Maximum water vapor content or compressed air …..      1.4g/N m3}
5. ^{Maximum oil vapor content of compressed air   ……..     0.1ppm}
6. ^{Maximum compressed-air consumption………            13.2 m3/h}

-INSTALLATION

→Propery ground all equipment in the spray area to an earth ground and maintain this ground

→Remove all containers of volatiles from the spray area

→Establish and maintain a grounded area for the spray operator

→The gun of xseries must be connect to xcontrol unit

→OPERATION

→The operator should hold the gun in his bare hand

→If gloves are worm ,the palm should be out to assure skin to metal contact

→The operator should wear shoes with conductive shoes e.g leather

     Rubber shoes are not conductive .

→Ground the tip of the gun before cleaning or changing nozzles.

→When the gun is not in use , it should be hung so that the nozzle is within four inches of a grounded conductor

→The operator should wear a filter-type respiator anytime he is exposed to dusty conditions

→High pressure powder many cause injury ,Keep the rear switch  “off” position in no –use condiction

  MAINTENANCE

→Make a periodic confirmation of grounding to earh of all equipment in the spray area .

→Exercise good housekeeping practices , do not allow dirt or powder to accumulate on the feeder /powder unit , cable or gun.

→Keep the cabinet door